Compare ground engaging tools and wear parts by mounting system, geometry, material and application. These are attachment components, not complete buckets or breakers.
None of the advertisements match the required criteria.
No offer found in the “Ground engaging tools and wear parts” category?
Describe what you need, your timing and key requirements. After email confirmation and moderation, the request may reach verified companies.
2 short steps. Clicking the button does not publish anything.
Ask for an offer in “Ground engaging tools and wear parts”Describe your requirements in a separate request. Verified companies may respond after email confirmation and moderation.
Describe what you need
Confirm your email to complete your request
Your request is saved, but companies cannot see it yet.
Open the message from Motendo and click the request confirmation button.
After confirmation, we will review the content before publishing it.
Cannot find the message? Check Spam or Promotions.
Per page
How should listings be compared?
Tips, adapters, cutting edges, blades, bits, flails, pins and bushes contact material directly or protect more expensive work tools. The correct variant balances penetration, impact strength and abrasive wear life. A design suited to clay may not be the right choice for rock, scrap or highly abrasive material.
How can compatibility be confirmed?
Identify the system and part number first. For a tip, match adapter size, shape, retention and pin; for a cutting edge, record length, width, thickness, profile, hole count and spacing. Knives and flails also depend on direction, individual mass and set balance. Pins must match their bushes and required fit.
What should be compared before buying?
For new parts, ask about steel grade, heat treatment, hardened layer and recommended application rather than accepting a hardness number without a test method. Weld-on systems need the correct procedure and consumable; bolt-on parts need the specified bolt grade and clean seating face. Incompatible retainers can release a component during work.
How should a used or remanufactured part be assessed?
A used wear part only has value when remaining working dimensions can be measured. Look for cracks, bending, elongated holes and uneven wear. Inspect the adapter pocket on a tooth, the bolt line on an edge and ovality or seizure marks on pins and bushes.
What information should the seller provide?
Ask for system and part numbers, attachment or machine, material, dimensions and mounting method. Confirm quantity, left- and right-hand items, retainers, bolts and freight cost. For a rotating set, request individual masses or evidence that the supplied set is balanced.
Log in with Facebook
Log in with Google
